NOTE: This post contains affiliate links and codes, which means I’ll receive a commission if you purchase through my links and codes, at no extra cost to you. I only recommend products that I love. Please read my full disclosure here for more information.
Breastfeeding (if one chooses to do so) is one of the most challenging – but rewarding – aspects of motherhood.
For full-time working mothers, pumping is a dreaded necessity. It is essential in order to maintain supply while women are away from their babies.
It is also important to note that employers are legally required to allow mothers reasonable time to pump while at work – in a private space other than a bathroom – for one year following delivery.
I’m going to compose a step-by-step guide for pumping at work!
TIMING / FREQUENCY
You will need to pump – on average – at the same intervals (more or less) as you would normally breastfeed your baby. My first pump session was usually between 9-10 a.m., the second was during the lunch break, and the third was usually between 4-5 when I was wrapping up my work for the day.
LENGTH OF PUMP TIME
This varies from woman to woman. Some (lucky!) women are able to pump quite quickly – in as little as 10 minutes. For others, it takes longer for the milk to flow and for their breasts to empty fully. Personally, it took me 30 minutes (including setup and cleanup) to pump each session.
A pumping bra (allowing mom to remain hands-free) is essential in order to complete work tasks while breastfeeding. Multitasking is key! It will help you avoid that rising feeling of panic that comes from getting behind on work while pumping.
1) In the morning…place each phalange (with attached parts) in a separate gallon size ziploc plastic bag. You will place these 2 plastic bags in your breast pump bag, along with a sharpie pen, breast milk bags, and your breast pump + cord.
2) When you are ready to pump…attach each phalange to each breast via hands-free pumping bra.
4) When finished, you will need to pour the milk collected into the pre-sterilized milk bags stored in your pump bag; you will use the sharpie to label the time, date, and amount of milk pumped.
5) Store milk in a refrigerator.
6) Clean pump parts (suggestions for this below).
7) Repeat at next pump.
8) When done for the day, take milk and pumping bag (containing pump parts) home, and immediately store milk in the freezer upon arrival.
9) Clean pump parts thoroughly with Dawn and water; allow to air dry on a paper towel or drying rack overnight.
This is probably one of the most challenging aspects of pumping at work. For many, who have only a cubicle for their work space, finding a place to wash (and dry) pump parts is daunting. It takes time to wash pump parts, and finding a place to allow them to air dry can be difficult as well.
When I was pumping, I used to place my pump parts in a plastic bag in the refrigerator in between pumps in order to avoid washing pump parts between pump sessions. Although I did this successfully with no issues for both my children, the CDC now recommends washing between sessions regardless. Therefore, I do recommend washing the parts between sessions, per official health agency recommendations, in order to avoid bacterial contamination. The quickest way to do this is to employ special breast pump part cleaning wipes (more on this below, in my “Recommended Products” section).
1) Baby Buddha Breast Pump – I used Spectra for pumping with my first child since it’s one of the pumps which most insurance plans cover. With my second child, however, I used the Baby Buddha Breast Pump. It was a complete game changer – it helps with portability, milk output, increasing supply, and hands-free pumping. I was able to dramatically increase my pumping output at work with this pump! Plus, the pump itself is the size of an iPhone and hangs around your neck with a strap. It is not covered by insurance, but it is worth every penny! (Often times, you get what you pay for, and this is certainly the case here!) Although this pump is listed at $249.99 on the website, it is often on sale for $189.99. You can get a 10% discount when purchasing this pump at the website with this code – MAKEUPDIVA10. Please read my full review here.
2) Hands Free Pumping Bra – As stated above, a hands-free pumping bra is a must-have for pumping at work. It allows multitasking in a way which is impossible otherwise. I personally used the hands-free pumping bra from Motherhood Maternity (featured below).
3) Cleaning Wipes – Obviously, cleaning with Dawn and water is ideal, but, if time and space are lacking, these quick cleaning wipes from Medela are a Godsend! I also love cleaning baby toys with this as well.
4) Breast Milk Bags – These milk bags from Lansinoh are iconic, and for good reason. They rarely leak or burst, and they are easy to use. It’s not recommended to store more than 180 mL of milk in these bags.
5) Pump Bag – Having a good pump bag is essential. It allows you to store your pump and parts, as well as accessories such as breast milk bags and “the sharpie.” I used this one below, and it served me well.
6) Milk Storage Bag – While some pump bags (such as above), do contain a compartment for breast milk, some don’t (in which case you will need to find one such as below).
Hope this was helpful!